Technical Discussion about the Electrical & Lighting related to the Ryker
6 posts • Page 1 of 1
Has anyone else experienced a clip that holds the wiring for the turn signal come loose? This is on the right fender. I was riding and sounds like rubbing against the tire , and noticed the wire clip is hanging loose. Any thoughts or shared experience with this?
Yes, Mine was doing same thing. Burnt thru wire, repaired and put clip back on tiny post but might have to drill small hole and safety tie it in the future if it comes off again.
- Bare Wire.jpg (42.52 KiB) Viewed 1417 times
- IMG_0599 a.jpg (31.95 KiB) Viewed 1417 times