Turn signal fender wire clip

Technical Discussion about the Electrical & Lighting related to the Ryker
Post Reply
Message
 
Shaolin
Posts: 2
Joined: Thu Jul 25, 2019 7:33 am
Has thanked: 0
Been thanked: 0

Turn signal fender wire clip

#1 Post by Shaolin » Thu Jul 25, 2019 7:52 am

Has anyone else experienced a clip that holds the wiring for the turn signal come loose? This is on the right fender. I was riding and sounds like rubbing against the tire , and noticed the wire clip is hanging loose. Any thoughts or shared experience with this?

TripleTree
Posts: 38
Joined: Tue Aug 13, 2019 7:36 pm
Has thanked: 0
Been thanked: 5 times

Re: Turn signal fender wire clip

#2 Post by TripleTree » Fri Aug 23, 2019 7:50 am

Yes, Mine was doing same thing. Burnt thru wire, repaired and put clip back on tiny post but might have to drill small hole and safety tie it in the future if it comes off again.
Attachments
Bare Wire.jpg
Bare Wire.jpg (42.52 KiB) Viewed 374 times
IMG_0599 a.jpg
IMG_0599 a.jpg (31.95 KiB) Viewed 374 times

TripleTree
Posts: 38
Joined: Tue Aug 13, 2019 7:36 pm
Has thanked: 0
Been thanked: 5 times

Re: Turn signal fender wire clip

#3 Post by TripleTree » Mon Nov 04, 2019 5:07 pm

IMG_1151.jpg
IMG_1153.jpg
Came off again, I removed both factory clips then drilled small hole in tab on inside of both fenders reattached with safety ties. PROBLEM SOLVED!
IMG_1154.jpg

TripleTree
Posts: 38
Joined: Tue Aug 13, 2019 7:36 pm
Has thanked: 0
Been thanked: 5 times

Re: Turn signal fender wire clip

#4 Post by TripleTree » Mon Nov 04, 2019 5:14 pm

Here's a picture of the clips that will not hold. I suggest replacing them with safety ties before your tire burns threw your wiring harness.
Attachments
IMG_1152.jpg

Post Reply